|Home||» Products||» PULP MILL PLANT||» RAG CUTTER|
RAG CHOPPER: -
PURPOSE: The Machine is used to cut the Rags into small pieces up to ½”x1” length and the Machine is capable for cutting the Rags 600 to 700 kgs. Per hours. Particulars of Rags Chopper machine are as under:-
BODY: M.S. Fabricated Body made out of 12mm Thick M.S. plate having a provision of dead knife holder.
ROTOR ASSEMBLY: M.S Steel Fabricated Rotor 450 mm ⌽ x 470 mm face length having a provision of six fly knives fitted on M.S Shaft with bearing 2218K and Plumber Block.
KNIVES: - 6 nos. Fly knives of size 450 x 120 x 16 mm & 1 no. Dead Knife of Size 480 X85 X 25 mm.
PULLEY & FLY WHEEL: The Rotor assembly will be fitted with a C.I Pulley C- Section 4 grooves & A fly wheel of 450mm ⌽ on the other side of the Rotor shaft is fitted for balancing propose .
INFEED & DISCHARGE CONVEYOR :In feed conveyor and discharge conveyor with 500 mm width and 2 meter length are provided for feeding the rags with 2 Nos. feeder rolls.
H.P:- 15 H.P. Motor x 960 RPM will be required for the machine. The Machine will be run at 450 RPM.
3H.P X 1440 required for the conveyer drive.
AKAR SHAKTI ENGG. INDUSTRIES All Rights Reserved.