|Home||» Products||» PULP MILL PLANT||» Breaker Beaters|
Ø BREAKER BEATER:-
Purpose: This machine is used for beating the rags. The rags without dust are used for the purpose for making the good pulp. Other detail of the machine is as under:
FRAME: 2Nos. Sturdy rigid and heavy-duty frames M.S. fabricated are grouted on both sides of RCC chest. 2nos. fabricated arms are fitted in the above frames on which the rotor is mounted with the help of bearing and plumber block with lowering and lifting arrangement as per requirement.
ROTOR: 3Nos. C.I.discs of heavy-duty are fitted on EN-8 shaft 120mm dia into 2950mm. Long. 72 nos. Carbon steel knives 760mm long x 8mm. thick are fitted with the help of shisham woods in the C.I.Discs and finally locked with locking rings & supported with 6 nos. scrapers from the both sides. The Dia of the rotor become 915mm x 760mm face length.
CHEST: Beater chest is made from RCC material with a partition in between in which rotor assembly is fitted on one side and washing drum assembly on the other side.
BED PLATE: Bed box along with Bed knife 9 Nos. of high carbon steel 790mm length x8/10mm thickness are grouted under the rotor assembly in RCC chest at an inclination angle of 5 degree.
WASHING DRUM: The washing drum is fabricated from M.S. Sheet size 710mm Dia x 710mm face. 4 nos. internal wash water Sheet for scooping the water out are in the washing drum. The drum is finally covered with M.S/S.S wire netting 40 mesh etc.
HOOD: The rotor guard/cover in the shape of semi circular is called rotor Hood which is fabricated from M.S. and the same is covered with the help of wooden planks. After installing the rotor assembly in the RCC chest. The rotor is covered with rotor guard/cover called hood. The cover is ment for protecting the pulp splashing out with rotor speed. A doctor plate wooden plank is fitted inside the hood at a proper angle, which help for the follow of pulp in the beater chest.
DRIVE: the machine drive will be arranged with the help of electric motor 30HP fitted on M.S.frames/rails along with motor pulley and control panel etc.
PULLEY: Driven pulley size 915 mm Dia v groves four, C section will be supplied with machine.
AKAR SHAKTI ENGG. INDUSTRIES All Rights Reserved.